Enable OPC connections in your client (ClearSCADA, etc.).Open the RSLinx Classic Launch Control Panel and check ‘Always Run As Service’ and then start the RSLinx service using the Start button.From here we set up our hardware configuration for simulation. Your slot 1 might have another irremovable RSLinx module depending if you are running RSLogix Enterprise. Note: This step is very important or RSLinx will not startup as a service. In slot 0 is an RSLinx module which has to be there for the emulator communications to work. Click ‘Done’ and then close the RSLinx Classic App.This updates the shortcut to reference the proper Driver/device. Once you have selected the proper controller, click ‘Apply’ at the bottom of the screen. #RSLINX CLASSIC LITE MODULE CONFIGURATION DRIVER#Then using the Data Source tree on the right hand side, navigate to the correct driver and controller. To re-link a ‘shortcut’, click on the shortcut.If the driver tree did not expand the shortcut needs to be re-linked. The driver tree on the right should expose the PLC or controller that shortcut is linked to. In the left panel, click on a device/shortcut. #RSLINX CLASSIC LITE MODULE CONFIGURATION DRIVERS#On the right you will see the drivers configured in RSLinx and any devices that are communicating via those drivers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |